Stainless Steel Fin Screws for Longboard and SUP

Never again will you need a screwdriver to install, adjust, or remove your longboard fin or stand-up paddleboard fin. Originally designed for the iSup market, the "No Tool" longboard screws and plate hold your center fin in place just as before, but they are tightened by hand and held in place by the spring force of an o-ring. Be overjoyed by never needing a screwdriver, being able to adjust your fin position mid-session, and spending more time on the water, whether that be on your SUP board, inflatable SUP, or a 9'0" noserider.

The quality-built, clean-edged, and smooth-threaded "No Tool" screws and plate are compatible with all standard fin boxes. They are designed to work with any fin, whether you call it a skeg or a fin. All Santa Barbara Surfing products are quality-built, with no fluff gear to get you out on the water.

Rider-tested on world-class point breaks, the company's mission is to spread quality gear far and wide to their water-sliding friends. This product can be compared to the E-Z Bolt, Wonderbolt, Quick Fin Release (QFR), or Thumbscrew versions.

The key features of the "No Tool" longboard screws and plate are:

NO TOOL REQUIRED: Hand-Tightening Against a Rubber O-Ring Means No Tools Ever RUST PROOF: 316 Stainless Steel Will Not Rust in Fresh or Salt Water COMPATIBLE WITH 99% OF BOARDS: Fits All Standard Surfboard Fin Boxes for Longboard, SUP, Single Fin, Paddleboard NOT COMPATIBLE WITH: Starboard & Naish Paddleboards, as these are reported to be too short for those boards SUPER VALUE: A 3-Pack Means You'll Have an Excuse to Buy More Boards

In conclusion, the "No Tool" longboard screws and plate offer a convenient and versatile solution for adjusting and removing your fin without the need for a screwdriver. Whether you're a longboarder, a SUP enthusiast, or a paddleboarder, this product can help you spend more time on the water and less time fiddling with tools.

product information: